project content admininistration
	list projects	new project

project
section
	edit step
id	21
sequence
text	Glue the bar in place in the bottom jaw. When the glue is dry, drill the three remaining 1/8 inch diameter pin holes in the lower jaw and bar. Glue the pins in place in the upper and lower jaw. Make sure not to glue the upper jaw pivot pin to the clamp. Sand the ends of the pins flush with the sides of the jaws. Sand all pieces through 180-grit paper. Put the upper jaw on the bar then glue the stop pin in place. Finish the clamps with several coats of tung oil.
src_1 [v]	select
src_2	select
src_3	select